This week we're featuring a jingle bell door hanger. My husband and my 3rd daughter helped out on this one.
You'll need metal jingle bells (15-25mm),
heavy gauge wire,
wire cutters, pliers,
1 inch metal rings (key ring) and some ribbon.
First decide how long you want your jingle bell hanger to be and add about two inches. Ours was about 12 inches.
Brian started by wrapping the wire around the key ring.
and kept wrapping until there are no sharp points.
Start threading your jingle bells onto the wire. We found that wrapping the end of the wire with florist's tape made threading easier.
Keep going until you reach the other end of the wire or run out of bells.
Then make a loop at the end to attach the ribbon.
Thread the ribbon through and tie in a bow.
And there you have it. A very simple and cheap project. If you wanted to make a wreath, just connect the end to the key ring and tie the bow at the top.
Any comments or questions, ask them here!
Leave a comment:
